Suggestions for cutting depth is not the same

When using beam press ,sometimes will happen the cutting depth is not the same for each side surface.

We would like give some the following suggestion :

1.Please make sure that installation position of the beam press is the same level in each side. If not ,please check that the ground is flat or not. Move beam press on the flat floor or put the rubber pad under the machine foot which will make all side of cutting table at the same level.

2.If the cutting table is in the same level .Please check the each side of upper beam is the same side or not. If not ,please adjust press beam to horizontal position.

3.Check the flatness of the blade. As well as the flatness of the cutting board.Both are need in the same horizontal position.

4.If you still have cutting depth problem ,please contact with us.